My car is making a whistling sound when I drive over 30mph. It does not make the noise while the car is idling. The noise stops when I stop.
Feb 13, 2013 at 10:46 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
Can you tell aprox where it is coming from?
Feb 13, 2013 at 11:33 PM
Advertisement
LEANNET
MEMBER
3 POSTS
Sounds like its coming from the front of the car. Just had front brake and rotors put on today.
Feb 14, 2013 at 12:10 AM
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
Did the sound change at all? Does the sound change when turning?
Feb 14, 2013 at 2:18 AM
LEANNET
MEMBER
3 POSTS
The sound hasn't changed with the new brakes. It doesn't change with turning.
Feb 14, 2013 at 3:11 AM
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
That is a tough one without being there. Check to see if there are any vacuum leaks on the engine. They can make a noise like that.
Intermittent wheel squeal / whistle. Probably right front, does not seem to have any real pattern such as cold or hot or speed changes. Does not change when braking and brake pads and calipers are free and look fine. Sound starts with no warning and goes away the same way. Usually lasts for a few minutes at a time and will usually go away for days. Occurs at any speed, all the way from 0 to 60. Every time I have tried to have someone help find the source, it disappears. Anyone else have this and find a cure?
Mar 16, 2019 at 9:25 AM
(Merged)
JDOT300
MEMBER
1 POST
i am having the same issue with my 2006 Pontiac Torrent. I have replaced the brakes and the hub assemblies but it still makes the noise. Does anyone have any suggestions?
Mar 16, 2019 at 9:25 AM
(Merged)
PROMECHANIC
CAR REPAIR CONTRIBUTOR
536 POSTS
So the wheel bearing are new and the brake pads are new. What areas did you lubricate when you replaced the brake pads?
Did you replace the front and the rear?
Does your car have drum brakes on the rear or disc?
Mar 16, 2019 at 9:25 AM
(Merged)
JOE MC
MEMBER
1 POST
Have a 2012 Chevrolet Equinox FWD. It developed a high pitched squeal between 15-55 mph and I initially thought it was a wheel bearing. I had only bought the vehicle used the day before so to say I was upset is an understatement. I removed the front wheel and noticed everything was greased well and the hub assembly looked fairly new for a 2012 model. Upon further inspection I noticed the heat shield plate behind the rotor was bent and pressing against the rotor. I bent the metal back so it was no longer pressed against the rotor and it solved the problem. Not sure if my son had hit a curb or what happened but I was happy to not have to replace the hub assembly. Hope this simple fix helps someone else. Really like this page even if a lot of the comments are older.
Sep 18, 2021 at 12:14 PM
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
Hi,
Thanks for that information, Joe. It will help others and is appreciated.