does the rear panel just pop off? I don't want to force anything
Jan 29, 2012 at 3:14 PM
how do I remove a 2005 acura mdx rear wiper motor?
2005 ACURA MDX
JAGOSTA
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
REAR WINDOW
1. Remove the tailgate trim panel (see TRIM REMOVAL/INSTALLATION TAILGATE AREA ).
2. Disconnect the 4P connector (A) from the rear window wiper motor (B).
Fig. 17: Disconnecting 4P Connector From Rear Window Wiper Motor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Test the motor by connecting battery power to the wiper motor 4P connector No. 1 terminal and grounding the No. 3 terminal. The motor should run.
4. Connect an analog voltmeter between the No. 4 (+) and No. 2 ( ) terminals, and run the motor. The voltmeter should indicate 0 V and 4 V or more alternately.
5. If the voltmeter does not indicate as specified, replace the rear window wiper motor.
1. Remove the tailgate trim panel (see TRIM REMOVAL/INSTALLATION TAILGATE AREA ).
2. Disconnect the 4P connector (A) from the rear window wiper motor (B).
Fig. 17: Disconnecting 4P Connector From Rear Window Wiper Motor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Test the motor by connecting battery power to the wiper motor 4P connector No. 1 terminal and grounding the No. 3 terminal. The motor should run.
4. Connect an analog voltmeter between the No. 4 (+) and No. 2 ( ) terminals, and run the motor. The voltmeter should indicate 0 V and 4 V or more alternately.
5. If the voltmeter does not indicate as specified, replace the rear window wiper motor.
Image (Click to enlarge)
Jan 29, 2012 at 6:27 PM
Advertisement