LIGHTS

2004 SUZUKI FORENZA
87,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
AXLEROD
  • MEMBER
  • 5 POSTS
Hi. I have a 2004 suzuki forenza . I changed the muti lever switch on steering column because i thought that was the reason my bright lights would not come on. Everything works but high beam. High Beam only works in pass mode. Yesterday i pulled low beam fuse from under the hood with lowbeam lights on with engine running. when i did the passenger side low beam light didn't go out but driver side did.
When i went to my owners manual in glove compartment it told me the H7 bulb was lowbeam and H1 bulb was the Highbeam but H1 has one prong and H7 has 2 prongs. Shouldn't H7 be the highbeam bulb. Need a good good eleatrician. P.S. PLEASE HELP
THANKS
Nov 15, 2010 at 5:59 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS

Symptoms indicates you have replaced a faulty multifunction switch with a bad one. Get another switch to test.

Our database does not indicate the bulb specification except that it is 55W.

From the headlight diagrsm shown, the 2 prong bulb is the inner one, nearer to center of vehicle.

Low beam has 2 fuses, one for each side, if you puled only one, the other would still work.
Nov 15, 2010 at 8:19 PM
Advertisement