2004 Mercury Sable turn signal

2004 MERCURY SABLE
90,000 MILES
Avatar
MECHCANICS
  • MEMBER
  • 1 POST
Signal arm does not return to neutral position after completing your turn. I am thinking of replacing it with a product from a salvage yard and need to know how to remove it from the car. I understand there are two screws that hold it in but after removing screws is it necessary to pull it out laterally or is it pulled upward.
Aug 11, 2013 at 11:03 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
You will need to remove the steering wheel to access the switch. It sounds like the plastic cancel tab is broken off. Make sure to disconnect the battery and wait at least 30 minutes before working on or around the airbag.
Aug 11, 2013 at 9:18 PM
Advertisement