Key broke off in ignition and will not go into on position to remove cylinder

2004 CHEVROLET MALIBU

215,000 MILES • 2.2L • 4 CYL • 2WD • AUTOMATIC

RHEE BABER REESE

MEMBER
1 POST

The key is in the off position. The shifter is in park. The steering wheel moves freely. I have seen numerous videos/comments about changing the switch and/or tumbler. Most of these say that the key must be in the "on" position. How can I remove ignition without being in on position?? Please help!

Sep 1, 2020 at 3:05 AM

JACOBANDNICKOLAS

✓Experienced Mechanic
110,240 POSTS

Hi,

It shouldn't be necessary. Here are the directions from my manual. The attached pics correlate with the directions. Let me know if they help.

____________________________

2004 Chevrolet Malibu L4-2.2L VIN F
Ignition Switch Lock Cylinder - Dash Mounted
Vehicle Starting and Charging Sensors and Switches - Starting and Charging Ignition Switch Ignition Switch Lock Cylinder Service and Repair Removal and Replacement Ignition Switch Lock Cylinder - Dash Mounted
IGNITION SWITCH LOCK CYLINDER - DASH MOUNTED
Ignition Switch Lock Cylinder Replacement

Removal Procedure

1. Remove the knee bolster.
2. Turn ignition switch to the run position.
3. Push the ignition lock cylinder tab.

pic 1

4. Remove the ignition lock cylinder.

Installation Procedure

pic 2

Important: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding.

1. Install the ignition lock cylinder.
2. Install the knee bolster.
_____________________________

Let me know.

Joe

Images (Click to enlarge)

Professional Diagram for 2CarPros Members
Click here to log in and view diagram.

Sep 1, 2020 at 11:48 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.