Fuel Pump and Fuel Filter

2004 KIA SEDONA
145,000 MILES
Avatar
L POWELL
  • MEMBER
  • 2 POSTS
As recommended both pump & filter were changed. Vehicle turns over but will not run. No codes show up when code reader used, Pump is working. Can fuel flow be interrupted anywhere? Can there be a air block? If so how would it be corrected? Is there a "in line filter"?
Jun 22, 2013 at 12:13 PM
Advertisement
Avatar
DOCFIXIT
  • CERTIFIED EXPERT
  • 18,828 POSTS
This sounds like a crankshaft sensor that has gone out which will not set a code, here is a guide to show you what you are in for when doing the job. Also check the timing belt.

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

Here is the location for you car and the timing belt diagram.

https://www.2carpros.com/diagrams/kia/sedona/2004

Check out the diagrams (Below)

Please let us know what you find.

Cheers
Image (Click to enlarge)
Attached Media
Jun 22, 2013 at 12:20 PM
Avatar
L POWELL
  • MEMBER
  • 2 POSTS
Yep it was the crankshaft sensor I replaced it and it started right up I got the sensor for $56.00
Jun 26, 2013 at 12:30 PM
Advertisement