Advertisement

jeep wrangler 4.0L

6 CYL • 4WD • AUTOMATIC
Avatar
DENTINO
  • MEMBER
  • 2 POSTS
runs rough at idle, checked fuel preasure 45 psi. Cylinders have 160 psi except cyl #1 at 140 psi. new plugs and coil no vaccume leaks, and there is no check engine light and all obd monitors are set to ready. but it did burn a 1 qrt of oil in 3 days. this is a recent motor swap so if u could help would be great!
Feb 21, 2011 at 5:53 AM
Advertisement
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
do a leak down test on the low cylinder, this may be the cause of your oil loss if it is rings, how much of the original engine was swapped over , as in fuel system and sensors?

mhpautos
Feb 21, 2011 at 6:00 AM
Advertisement
Avatar
DENTINO
  • MEMBER
  • 2 POSTS
all sensors from the new motor were used. as well as just the injectors and rail everytheng else was from the original engine
Feb 21, 2011 at 6:04 AM
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
If this motor was sitting for a while the injectors could be a bit sticky, if you can i would swap the injectors from original engine, if you don't have them, get yours serviced.

mhpautos
Feb 21, 2011 at 6:07 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle