2004 HYUNDAI TIBURON
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I am trying to replace the clutch and I can not get the transmission to come loose of the motor. All bolts have been taken off
Apr 4, 2013 at 6:10 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JEREMYMEDBERY
  • MEMBER
  • 1 POST
Connected to the slave cylinder is a lever aytached to your clutch fork. Take that bolt off, flip the lever upside down and replalace the bolt screwing it on a couple spins. Grab the lever, lift up and turn.... This will release the fork from the T.O.B. In turn allowing the transmission to come free of the motor.
Apr 10, 2013 at 10:46 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
yes, the throwout bearing has to be released to remove the trans

Roy
Apr 15, 2013 at 3:39 AM
Advertisement