2004 Honda Odyssey gears won't engage

2004 HONDA ODYSSEY
178,000 MILES
Avatar
LAURA G
  • MEMBER
  • 1 POST
My 2004 honda Odyssey gears won't engage. The gear shift moves easily and smoothly but stays in "park" , won't engage any gear. Car has been working fine. I parked car to pick up my son after school; 5 minutes later when I started car the gear shift would move but no gears would engage. Car is stuck at school. Is there a cable or some other sort of connector that could have snapped or disconncted to cause this to happen so out of the blue? Looking like I need to tow it somewhere unless there is a way to get under car and see if anything is needing to be re-connected. This is our only family car....Any ideas?
Feb 14, 2014 at 5:17 PM
Advertisement
Avatar
CARADIODOC
  • ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
The cable is a likely suspect but it's more common for them to become disconnected than it is for them to break. Look under the hood to see if you can see the end of the cable moving when a helper moves the shift lever.

If the lever on the transmission doesn't move, you can get by, again, with a helper, by moving that lever by hand. You'll need to start the engine first, hold the brakes applied, then the helper has to move the lever by hand to place it in "drive". At that point you can drive normally, but only forward. The helper will have to shift it under the hood to use "reverse", and once you stop the engine you'll have to shift it back to "park" or "neutral" to start the engine again.
Feb 15, 2014 at 3:34 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.