how do you remove heater blower fan 2004 F150 super crew fan makes a rattiling or rumbling noise at all fan speeds
Dec 31, 2010 at 7:20 PM
Heater fan motor
2004 FORD F-150
GEORGE DAGENAIS
- MEMBER
- 1 POST
Advertisement
MERLIN2021
- ✓ASE Certified Mechanic
- 17,250 POSTS
BLOWER MOTOR
Up under the dash on the passenger side is the location of the motor, remove the right kick panel, peel back the rug, remove the plugs, then the blower.
Removal and Installation
1. Remove the RH lower A-pillar trim panel.
2. Position aside the carpet below the blower motor.
3. Remove the blower motor (19805)
1. Remove the blower motor screws.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor.
Fig. 207: Removing Blower Motor
Courtesy of FORD MOTOR CO.
4. Remove the blower motor wheel (18504).
1. Remove the clip.
2. Remove the blower motor wheel.
Fig. 208: Removing Blower Motor Wheel
Courtesy of FORD MOTOR CO.
5. To install, reverse the removal procedure.
Up under the dash on the passenger side is the location of the motor, remove the right kick panel, peel back the rug, remove the plugs, then the blower.
Removal and Installation
1. Remove the RH lower A-pillar trim panel.
2. Position aside the carpet below the blower motor.
3. Remove the blower motor (19805)
1. Remove the blower motor screws.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor.
Fig. 207: Removing Blower Motor
Courtesy of FORD MOTOR CO.
4. Remove the blower motor wheel (18504).
1. Remove the clip.
2. Remove the blower motor wheel.
Fig. 208: Removing Blower Motor Wheel
Courtesy of FORD MOTOR CO.
5. To install, reverse the removal procedure.
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Apr 19, 2021 at 11:18 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.