2004 Dodge Stratus Car Ran Fine Alternator Went Out Replaced Now Won T Start On

2004 DODGE STRATUS
175,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Car ran fine then the alternator went out. Replaced the alternator and now the car won't start on the first try but does on a second try. Then it revs itself. The battery had been disconnected for 2hrs while I worked on it. Why would this be happening
Dec 11, 2012 at 5:30 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
The Engine Computer lost its memory and has to relearn "minimum throttle" before it will know when it must be in control of idle speed. It also might not give you the normal "idle flare-up" to 1500 rpm when you start the engine. To meet the conditions for the relearn to take place, drive at highway speed with the engine warmed up, then coast for at least seven seconds without touching the brake or gas pedals.

To get it started, just hold the gas pedal down 1/8". You'll also have to keep your foot on the pedal at stop signs until the relearn is done.
Dec 11, 2012 at 10:12 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.