2004 CHRYSLER SEBRING
Avatar
RUTHLESS79
  • MEMBER
  • 3 POSTS
Recently put a used motor in my 2004 Chrysler Sebring Sedan 2.4L 4cyl DOHC. Before installing used motor I had put a new camshaft sensor on original motor and made sure to transfer this to used motor...Also, crankshaft sensor is in different location on used motor. When key is turned on I have power to coil as fuel pump runs for a few seconds...Car will crank, but will not start. There is no spark....Please help!!!
Oct 22, 2012 at 5:45 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
do you have other sensor to put in and try?
Oct 22, 2012 at 6:22 AM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
did youy even hook up the sensor????

Roy
Oct 22, 2012 at 11:34 AM
Avatar
RUTHLESS79
  • MEMBER
  • 3 POSTS
Yes, the crankshaft sensor is hooked up. Just thought I'd mention that it is in a different location on used motor than on original motor.
Oct 22, 2012 at 3:56 PM
Avatar
RUTHLESS79
  • MEMBER
  • 3 POSTS
Also, my boyfriend has checked fuses and all seem to be working. Does anyone have any suggestions?? Please help!
Oct 22, 2012 at 7:11 PM
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
hopefully the motor you put in matches your computer system. like i said, did you try cam sensor that CAME with motor? is it installed right? recheck things. who installed motor?
Oct 23, 2012 at 5:48 AM