2004 Chevrolet Trailblazer Replacing ADJUSTER.

Tiny
VENEZOLANO
  • MEMBER
  • 2004 CHEVROLET TRAILBLAZER
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 130,000 MILES
Good afternoon. I need to replace the part numbered 37 in the attaced diagram ( also shown in the web page:
http://parts.nalleygmc.com/showAssembly.aspx?ukey_assembly=437923&ukey_product=2631187
)
But I don't know how to replace the part No 38 in the same diagram. It is a thin piece and I think it is very easy to damage it.
Could you tell me how to proceed please?
Thanks.
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Tuesday, September 9th, 2014 AT 1:08 PM

8 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
If I am correct, I am looking at a differential and you need to replace the pinion bearing and seal. If that is correct, part 38, the pinion seal, is not thin. Actually, it will need tapped into place with a hammer. I always place a piece of wood over it so I don't damage the seal and then tap on it.

Does this sound like what you are doing?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, September 9th, 2014 AT 6:10 PM
Tiny
VENEZOLANO
  • MEMBER
  • 7 POSTS
Thanks a lot.
In the attached picture it is shown the piece I want to replace and the thin piece I do not want to damage.
Now I think I was wrong and I did not pointed the correct pieces in the diagram.
Was this
answer
helpful?
Yes
No
Wednesday, September 10th, 2014 AT 6:48 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Hi:

The picture didn't come through. Can you try again?
Was this
answer
helpful?
Yes
No
Wednesday, September 10th, 2014 AT 8:50 AM
Tiny
VENEZOLANO
  • MEMBER
  • 7 POSTS
(The picture)
Was this
answer
helpful?
Yes
No
Wednesday, September 10th, 2014 AT 9:25 AM
Tiny
VENEZOLANO
  • MEMBER
  • 7 POSTS
(The same picture with a lower resolution)
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, September 10th, 2014 AT 9:33 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
That looks like an axle seal. If that is correct, it is basically as the one I described earlier.
Was this
answer
helpful?
Yes
No
Wednesday, September 10th, 2014 AT 5:18 PM
Tiny
VENEZOLANO
  • MEMBER
  • 7 POSTS
Ok. I am going to read your article.
Thanks
Was this
answer
helpful?
Yes
No
Thursday, September 11th, 2014 AT 7:22 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Keep in touch and let me know if you have other questions or how things go for you.
Was this
answer
helpful?
Yes
No
Thursday, September 11th, 2014 AT 6:15 PM

Please login or register to post a reply.

Related General Content

GUIDE
Inquire Here

Sponsored links