2004 CHEVROLET TRAILBLAZER
140,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
removed the front chunk for the 4wd i need to know how to remove the driveshaft from the transwer case
Mar 16, 2013 at 3:57 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
Do not have to remove the front crossmember! Unbolt diff end and position up above yolk and between steering gear boot. May have to turn yolk to get clearance. But there is plenty! Hold so free and then slide off the rear joint (cv style) from tcase. Slide the shaft to front of car up along engine towards motor mount to clear trans crossbrace then down and back out
Mar 16, 2013 at 3:17 PM
Advertisement