camshaft position sensor

2004 CHEVROLET MONTE CARLO
140,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
JONTHAN
  • MEMBER
  • 3 POSTS
where is ths camshaft position sensor on a 2004 Chevrolet Monte Carlo Ls 3400
Jan 25, 2011 at 1:52 AM
Advertisement
Avatar
ERNEST CLARK
  • CERTIFIED EXPERT
  • 1,730 POSTS
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE





Remove the power steering pump and reposition.
Disconnect the camshaft position (CMP) sensor electrical connector.
Remove the CMP sensor bolt.
Remove the CMP sensor.
Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
INSTALLATION PROCEDURE
Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.




Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.

Install the CMP sensor bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in) .

Connect the CMP sensor electrical connector.
Install the power steering pump.
Images (Click to enlarge)
Attached Media
Attached Media
Feb 27, 2011 at 1:15 AM