2004 CHEVROLET COLORADO
60,000 MILES
Avatar
LKORUS
  • MEMBER
  • 1 POST
I am trying to replace right front wheel bearings on a Chevy pickup. I have all the bolts loose on the back side of the axle housing but the axle will not come out. I have used a lot of wd40 because of a lot of rust. Any suggestions?
Dec 15, 2011 at 3:19 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
is it 2WD? did ya tap on hub it could be stuck.
Dec 15, 2011 at 3:47 AM
Advertisement
Avatar
JAREDSKI
  • MEMBER
  • 14 POSTS
heat it up and tap it with a dead blow hammer

Dec 15, 2011 at 9:52 PM