i just bought 2 new bulbs for my car on low beam one works and on high beams one works
Dec 28, 2014 at 4:42 PM
2004 Chevrolet Cavalier headlight
2004 CHEVROLET CAVALIER
JIMDUNN2013
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
So are the high and low beam bulbs that are inop on the same sides? Which bulbs were replaced? More details please iam not there to check and see whats going on.
Dec 28, 2014 at 5:27 PM
Advertisement
With the headlights on LOW, use a test light or voltmeter to check for power on the DARK/BLUE wire at the headlight socket (on the light that does not work on LOW).
With the headlights on HIGH, use a test light or voltmeter to check for power on the PINK wire at the headlight socket (on the light that does not work on HIGH).
If power is present, the connect terminals may be damaged or spread apart and not making a good connection.
If no power, (for LOW beam) check the DRK/BLU wire splice #105 which is located in the Forward Light Harness about 75cm from the horn connector.
If no power, (for HIGH beam) Check the PINK wire splice #107 which is located in the engine harness at the left rear of the engine, 13cm from cooling fan connector breakout.
Thanks.
Let me know how this goes.
With the headlights on HIGH, use a test light or voltmeter to check for power on the PINK wire at the headlight socket (on the light that does not work on HIGH).
If power is present, the connect terminals may be damaged or spread apart and not making a good connection.
If no power, (for LOW beam) check the DRK/BLU wire splice #105 which is located in the Forward Light Harness about 75cm from the horn connector.
If no power, (for HIGH beam) Check the PINK wire splice #107 which is located in the engine harness at the left rear of the engine, 13cm from cooling fan connector breakout.
Thanks.
Let me know how this goes.
Dec 28, 2014 at 5:36 PM
I replaced both sides and I will have high beam on driver side but not passenger side I will havelow beam on passange side but not driver side
Dec 28, 2014 at 5:37 PM