2003 Volvo S40 comprehensive component

1.9L • 4 CYL • TURBO • AUTOMATIC
Avatar
COCOALATTA1
  • MEMBER
  • 1 POST
How do I get my comprehensive component to read ready
Feb 7, 2015 at 1:37 AM
Advertisement
Avatar
DR LOOT
  • ✓Experienced Mechanic
  • 2,311 POSTS
I am assuming that your "comprehensive components" are the flags have not been set for an emissions test?solenoid

Check all diagnostic functions as follows.

•The test must take place on a road with little traffic where it is possible to drive slowly and stop at the side of the road.
•For all diagnostics to be carried out, the engine coolant temperature (ECT) must be between -7°C and 35°C when the engine is started before the test.
•Ensure that there are no diagnostic trouble codes (DTCs) stored in the engine control module (ECM) before carrying out verification.
Schedule

1.Switch the ignition on for 5 seconds.
2.Switch off the air conditioning (A/C).
3.Start engine. Allow the engine to idle for 10-20 seconds.
4.Accelerate gently to 70-80 km/h.
5.Drive at a steady throttle opening at 70-80 km/h for 15 minutes.
6.Engine brake down to 30 km/h (fully release accelerator pedal).
7.Stop the car. Leave the engine running.
8.Idle the engine for 1 minute.
9.Accelerate to 70-80 km/h (for manual transmissions, first gear up to 40 km/h in 5 seconds).
10.Switch on air conditioning (A/C).
11.Drive at a steady throttle opening at 70-80 km/h for 5 minutes.
12.Stop the car. Leave the engine running. Read off the data.
Feb 13, 2015 at 12:42 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle