In the diagnostic mode 1 what does beep/beep short pause and beep/beep indicate?

2003 OLDSMOBILE SILHOUETTE
148,000 MILES
Avatar
JOEGONE
  • MEMBER
  • 2 POSTS
I have a 2003 Olds Silhouette with power door problems. I went through module 1 to determine what the dianostic code would be, and I came up with two beeps a short pause and two beeps. This kept repeating itself with a long pause in between. What does this mean?
Jun 4, 2012 at 12:08 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
what scan tool are you using

Roy
Jun 4, 2012 at 1:52 AM
Advertisement
Avatar
JOEGONE
  • MEMBER
  • 2 POSTS
I am not using a scan tool. I was given directions to enter three different diagnostic modes by pushing the on/off button on the console. I was told that it will give me a series of tones and depending on the pattern they would correlate to a code. I got two beeps, short pause, and two beeps, these pattern contuned after a long pause.
Jun 4, 2012 at 3:36 AM