how do I change pollen filter on tino 2.2 SE+ diesel
Apr 6, 2013 at 5:27 PM
2003 NISSAN TINO
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
This is for a Sentra, procedures are similar.
Removal & Installation
1. Remove the glove box door by removing the 2 lower hinge pins. See Fig. 1.
2. Remove the 2 screws securing the glove box frame. See Fig. 2.
3. Remove the 2 screws securing the glove box latch. See Fig. 2. Remove latch by pulling it down. Remove the glove box frame by pulling it away from the instrument panel to disengage the retaining clips.
4. Remove filter cover from the intake unit by disengaging the 2 hook tabs at the bottom of the cover. Remove the in-cabin microfilter. See Fig. 3.
5. Slide the new filter into the housing. Ensure the filter is seated correctly. See Fig. 4. Replace the cover by inserting the upper tabs inside the housing slot and pushing the hook tabs until they snap onto the housing lip.
6. Install the glove box frame and latch. Install the glove box door.
NOTE:
The filter is marked "UP" with an arrow. The end of the filter with the arrow should face the rear of the vehicle.
Removal & Installation
1. Remove the glove box door by removing the 2 lower hinge pins. See Fig. 1.
2. Remove the 2 screws securing the glove box frame. See Fig. 2.
3. Remove the 2 screws securing the glove box latch. See Fig. 2. Remove latch by pulling it down. Remove the glove box frame by pulling it away from the instrument panel to disengage the retaining clips.
4. Remove filter cover from the intake unit by disengaging the 2 hook tabs at the bottom of the cover. Remove the in-cabin microfilter. See Fig. 3.
5. Slide the new filter into the housing. Ensure the filter is seated correctly. See Fig. 4. Replace the cover by inserting the upper tabs inside the housing slot and pushing the hook tabs until they snap onto the housing lip.
6. Install the glove box frame and latch. Install the glove box door.
NOTE:
The filter is marked "UP" with an arrow. The end of the filter with the arrow should face the rear of the vehicle.
Images (Click to enlarge)
Apr 7, 2013 at 3:48 AM
Advertisement