how do you remove a front wheel bearing on a nissan altima 2003 2.5s

2003 NISSAN ALTIMA
Avatar
DAVIDSFORBES
  • MEMBER
  • 1 POST
need to change bearing
Feb 2, 2012 at 11:54 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
That wheel bearing is a press in type You have to remove the axle nut and washer .Then get a slide hammer with a hub attachment to remove the hub. Then pop the lower ball joint loose and the outter tie rod end loose.Then if there is a snap ring remove it then get a on car front wheel bearing tool to remove and replace the wheel bearing.Or remove the knuckle hub assembly and take it to have the new bearing pressed in and then you will have to get a alignment.
Feb 3, 2012 at 12:13 AM
Advertisement