How do I install a Drive Belt? What is the layout?
Mar 13, 2013 at 5:01 PM
2003 MITSUBISHI MONTERO
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Refer to diagram.
Run belt over all the pullies except for the ones easiest to access and use a tool to push the tensioner and slip the belt over the last pulley.
After installation, release the tensioner. Get a good grip of the tensioner and push it again while you gently roll the belt over the pullies, this would ensure the belt is seated correctly.
Run belt over all the pullies except for the ones easiest to access and use a tool to push the tensioner and slip the belt over the last pulley.
After installation, release the tensioner. Get a good grip of the tensioner and push it again while you gently roll the belt over the pullies, this would ensure the belt is seated correctly.
Image (Click to enlarge)
Mar 13, 2013 at 5:47 PM
Advertisement