2003 Mitsubishi Lancer cranks but wont start

Tiny
LUNCHBOX763
  • MEMBER
  • 2003 MITSUBISHI LANCER
  • 186,000 MILES
Was driving, come to a stop light and while sitting at a red light car dies and wont start. I get a tow home pull a camshaft position sensor code P0340 "I think it is off top of my head" I test for spark and there's no spark, replace the cam pos sensor car still no start, but now have spark. I pulled the bottom hose off the fuel pressure regulator and get gas when I turn the car over, all fuses are good, I still get a camshaft position sensor code still have spark, wiring appears to look good, I am clueless as where to go from here.
Wednesday, August 7th, 2013 AT 11:31 PM

3 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
P0340 is a fault with the cam position sensor and if you are stil getting the code after replacement of the sensor, that could mean a fault with the wiring.

No spark is caused by the crank sensor and I would suggest checing that. Btw check and ensure the timing belt is intact.
Was this
answer
helpful?
Yes
No
Tuesday, April 20th, 2021 AT 11:45 AM
Tiny
LUNCHBOX763
  • MEMBER
  • 4 POSTS
Ok, checked timing belt and it is intact, now would a faulty crank position sensor allow spark to one coil and not the other being only two coil one per two cylinders
Was this
answer
helpful?
Yes
No
+1
Tuesday, April 20th, 2021 AT 11:45 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Yes, it is possible if the crank pickup point has problems.
Was this
answer
helpful?
Yes
No
Tuesday, April 20th, 2021 AT 11:45 AM

Please login or register to post a reply.

Sponsored links