front brakes

2003 MITSUBISHI GALANT
4 CYL
Avatar
KAMQAISI
  • MEMBER
  • 1 POST
i want to change fron brake pads on mitsubishi galant 2003 and want to know if i have to remove the caliper bolts or just the pin and i cannt locate the pin
Jan 11, 2011 at 3:43 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Remove only the lower pin bolt, item # 1 and you can flip the caliper upwards to gain access to the brake pads.

You might need a screwdriver to compress the piston slightly to flip the caliper if the rotor edges are thicker than the inner portion where the brake pads seats.

Remember to remove some fluid from the master cylinder if it is full as compressing the piston can cause the reservoir to overflow.
Image (Click to enlarge)
Attached Media
Mar 16, 2021 at 5:41 PM
Advertisement