2003 MERCURY MARQUIS
60,000 MILES
Avatar
LPEEK
  • MEMBER
  • 55 POSTS
2003 grand marquis need to replace driver side power window regular must i drill out the popribits that hold the glass to the regular to seperate the glass from the regulator. I must get them apart to remove the glass them remove the regulator. i don't see any to get the two apart without drilling out the ribits. i am sure this is specific to ford products, so I need a answer from someone that does body work on crown victoria or grand marguis thanks
Dec 12, 2012 at 8:51 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
yes, the must be drilled out. you can replace with nuts and bolts. drill enough to knock out the center of the riviet.

Roy
Dec 12, 2012 at 9:10 PM
Advertisement
Avatar
LPEEK
  • MEMBER
  • 55 POSTS
I replaced motor and regulator. My problem is with the window binding in the weather striping channel. I tried silecone spray but the window is still to hard to move up and down. Is there another type of lub or something I need to do to the window channel to let the window move freely. this is why the motor failed.
Dec 14, 2012 at 9:49 PM