How do I replace the cruise control switch by the brake pedal?
Dec 20, 2012 at 12:18 AM
2003 MAZDA TRIBUTE
THRDCHANCE
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
BRAKE PEDAL POSITION (BPP) SWITCH
REMOVAL
Remove the brake pedal position (BPP) switch.
Disconnect the electrical connector.
Rotate clockwise and remove the BPP switch.
INSTALLATION
NOTE: Initial installation of brake pedal position (BPP) switch allows for one adjustment. If additional adjustments are necessary, install a new switch.
To unlock, rotate the lock knob counterclockwise to the stop.
With the engine running, fully depress and hold the brake pedal.
Install the brake pedal position (BPP) switch.
Position the BPP switch in the bracket and rotate counterclockwise.
Connect the electrical connector.
Slowly release the brake pedal.
REMOVAL
Remove the brake pedal position (BPP) switch.
Disconnect the electrical connector.
Rotate clockwise and remove the BPP switch.
INSTALLATION
NOTE: Initial installation of brake pedal position (BPP) switch allows for one adjustment. If additional adjustments are necessary, install a new switch.
To unlock, rotate the lock knob counterclockwise to the stop.
With the engine running, fully depress and hold the brake pedal.
Install the brake pedal position (BPP) switch.
Position the BPP switch in the bracket and rotate counterclockwise.
Connect the electrical connector.
Slowly release the brake pedal.
Dec 20, 2012 at 12:25 AM
Advertisement