2003 Grand Cherokee Window Seal Replacement

2003 JEEP GRAND CHEROKEE
87,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
GOWRD
  • MEMBER
  • 2 POSTS
For a 2003 Grand Cherokee how do I remove the outer bottom window seal (one on each of the four doors) (I've bought replacements because the originals are rusting)
Feb 1, 2011 at 3:58 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ERNEST CLARK
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 1,730 POSTS
Window seals aren't metal, they're rubber. So they can't rust. Are you refering to a trim molding?
Feb 1, 2011 at 12:28 PM
Advertisement
Avatar
GOWRD
  • MEMBER
  • 2 POSTS
I believe the part is called a weather strip -its the strip that seals or keeps the water out of the door, which fits between the bottom of the window glass and the top of the door immediately below the window. My question is how to remove the old one and replace the new ones.
Thanks in advance
Feb 1, 2011 at 5:50 PM
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
they can have clips/rivets or screws holding them in. rol the window down and get a flat scredriver. put it behind the strip and pry it towards window. try at the end first then go further in until it is all the way disconnected. reverse the procedure but don't use the screwdriver just push it in if it's clips or screws, etc or rerivet it if that holds it in.
Feb 1, 2011 at 6:10 PM