2003 Jeep Grand Cherokee Laredo

2003 JEEP GRAND CHEROKEE
119,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
GWEN MATTINGLY
  • MEMBER
  • 1 POST
crank shaft sensor got pinched during a transmission repair. I have had several issues with jeep since including PCM bad, PCM fuse kept blowing, fuel pump bad, a computer going out, all within 1 day of getting jeep back from transmission repair. Could any of these problems be related.
Aug 3, 2011 at 7:35 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
yes if the sensor got pinched probably the wires were as well and it got grounded out.you shold be going to the trans shop to have them take care of the damage they have done.
Aug 3, 2011 at 8:46 PM
Advertisement