hyundai knock sensor

2003 HYUNDAI SANTA FE
6 CYL • 2WD • AUTOMATIC
Avatar
TEXHUSKER2
  • MEMBER
  • 1 POST
replaced engine in 2003 hyundai sante fe 2.7l engine ran quiet for about 15 mins, then started to knock. newer engine 23,000 miles i'm not sure if it's from a sante fe may have been a sonata. Is the knock sensor vehicle specific or engine? can i take my old one from engine and swap it out.
Jun 25, 2011 at 2:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
you can take the old one and fitit in the other engine block as long as it's the same thread. Knock sensor may or can be specific to application. But not always. is the knock from spark or is it an engine knock. make sure to check that out.
Jun 25, 2011 at 3:19 PM
Advertisement
Avatar
KHLOW2008
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 41,814 POSTS
Ensure the engine oil level is correct.

Does the knocking noise occur intermittently and seems to go away briefly when you feather the throttle?

Jun 25, 2011 at 9:12 PM