Rodeo Clutch

2003 HOLDEN RODEO
140,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
FASTGUNS
  • MEMBER
  • 2 POSTS
in a 03 v6 Rodeo 4x2,does the selector fork go under the release bearing or on top.?
Regards
Mar 20, 2011 at 6:59 AM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
not really sure what you are getting at here, the selector fork is internal of the gear box, and the release bearing is in the bell housing, i think we have a terminology problem.
Mar 20, 2011 at 10:41 AM
Avatar
FASTGUNS
  • MEMBER
  • 2 POSTS
My Fault ,I meant Shift fork,
regards
Mar 20, 2011 at 10:58 AM
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
maybe the clutch fork? selector and shift fork are the same thing, now if you have the clutch out and are re fitting the clutch release bearing it will clip onto the clutch fork with a wire clip ands the thrust face of the bearing is in contact with the clutch pressure plate fingers, are we getting close?
Mar 20, 2011 at 11:05 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.