How do I find a window motor and replace.
Jan 21, 2011 at 10:46 PM
2003 ford winstar
2003 FORD WINDSTAR
WHEELST
- MEMBER
- 2 POSTS
Advertisement
BMRFIXIT
- ✓ASE Certified Mechanic
- 19,053 POSTS
Are you looking for parts to buy or location and replacement procedure ?
Jan 21, 2011 at 11:35 PM
I found the part now looking for a replacement procedure
Jan 22, 2011 at 12:12 AM
BMRFIXIT
- ✓ASE Certified Mechanic
- 19,053 POSTS
Remove the front door trim panel.
Remove the watershield.
Disconnect the window regulator motor electrical connector.
NOTE:Check the interior of the door to make sure the front window regulator wiring is not in line with the holes to be drilled into the door inner panel.
Using a 12.7 mm (0.5 in) drill bit, drill out the drill dimples.
WARNING:The window regulator motor has a counterbalanced spring.
The window must be in the up position to remove the motor or blocked to prevent the window from suddenly raising. Failure to follow these instructions may result in personal injury.
Remove the bolts and the window regulator motor
Remove the watershield.
Disconnect the window regulator motor electrical connector.
NOTE:Check the interior of the door to make sure the front window regulator wiring is not in line with the holes to be drilled into the door inner panel.
Using a 12.7 mm (0.5 in) drill bit, drill out the drill dimples.
WARNING:The window regulator motor has a counterbalanced spring.
The window must be in the up position to remove the motor or blocked to prevent the window from suddenly raising. Failure to follow these instructions may result in personal injury.
Remove the bolts and the window regulator motor
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Jan 23, 2011 at 3:04 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.