check engine light is on and camshaft positioning sensor is going out

2003 DODGE TRUCK
126,535 MILES • V8 • 2WD • AUTOMATIC
Avatar
DAN ROBERTS
  • MEMBER
  • 1 POST
camshaft positioning sensor is going out how hard is it to change one
Nov 26, 2010 at 5:07 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
The Camshaft Position Sensor (CMP) on this engine is bolted to the front/top of the right cylinder head.

REMOVE

Raise and support vehicle.
Disconnect electrical connector at CMP sensor.
Remove sensor mounting bolt.
Carefully twist sensor from cylinder head.
Check condition of sensor O-ring.


Image (Click to enlarge)
Attached Media
Nov 26, 2010 at 5:55 PM
Advertisement