Timing problem

2003 CHRYSLER SEBRING
67,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
DANADANA
  • MEMBER
  • 1 POST
Just bought a 2003 Chrysler Sebring 3.0 2dr. Seller said in needed a timing belt. Started to install a new timing belt, but found out it already had a new belt in it. I shows sparks when turning over. Timing marks on both cams and crankshaft were ok for piston #1. It turns over but doesn't fire, it sounds like timing belt is broken, is not working at all.

Thanks!



..
May 21, 2011 at 7:15 PM
Advertisement
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Engine cranking, if you have spark at all the plugs, use a gage and check fuel pressure. Check cylinder compression. You didn't test drive the vehicle? You bought a vehicle that would not start and run?

Any applicable trouble codes, you may need to use an obd 2 code reader.
May 22, 2011 at 9:28 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle