SPONSORED LINKS

Timing problem

Tiny
DANADANA
  • MEMBER
  • 2003 CHRYSLER SEBRING
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 67,000 MILES
Just bought a 2003 Chrysler Sebring 3.0 2dr. Seller said in needed a timing belt. Started to install a new timing belt, but found out it already had a new belt in it. I shows sparks when turning over. Timing marks on both cams and crankshaft were ok for piston #1. It turns over but doesn't fire, it sounds like timing belt is broken, is not working at all.

Thanks!



.
SPONSORED LINKS
Sunday, May 22nd, 2011 AT 2:15 AM

1 Reply

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Engine cranking, if you have spark at all the plugs, use a gage and check fuel pressure. Check cylinder compression. You didn't test drive the vehicle? You bought a vehicle that would not start and run?

Any applicable trouble codes, you may need to use an obd 2 code reader.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Sunday, May 22nd, 2011 AT 4:28 PM

Please login or register to post a reply.

Related Ignition Timing Content

VIEW MORE

Sponsored links