engine sounds fine but when reved, knocks

2003 CHRYSLER SEBRING
112,000 MILES
Avatar
MKHAMIS90
  • MEMBER
  • 3 POSTS
I have a 2003 Chrysler Sebring 3.0 coupe I have 2 questions first one is when I have. The car at idle the engine sounds fine but when I rev it or gas it the engine knocks a little what can I do to fix it. 2nd question is when I take off or switch from reverse to drive I hear popping is that from the av axle or the bearings
May 26, 2012 at 3:45 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
have the CV joints checked for the popping noise. As far as the engine knock, is the oil clean and full?
May 26, 2012 at 5:29 AM
Advertisement
Avatar
MKHAMIS90
  • MEMBER
  • 3 POSTS
Cv joints the same as the cv axle ?
And the oil is full Im not sure about clean though
May 27, 2012 at 11:12 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Yes, the CV joints are on the axle.
May 29, 2012 at 2:35 AM
Avatar
MKHAMIS90
  • MEMBER
  • 3 POSTS
K and about the knock should I flush the engine and pour synthetic oil
May 29, 2012 at 4:16 PM