There is no power, motor is good as well as switch. What could it be, can u assist?
Wednesday, September 28th, 2011 AT 2:16 AM
9 Replies
JACOBANDNICKOLAS
MECHANIC
109,700 POSTS
Check the fuses, check the wiring between the door and the door frame. It isn't uncommon for one to break there.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 2:20 AM
CABRERA
MEMBER
4 POSTS
Ok, I checked the fuses and they all work. I tested the switch and that also works. I did not see any broken wires in the door panel. Now I tested the wires that are connected to the motor and there is no power running. I also tested the motor with a direct wire from my batterie and it spinned, iam assuming its working. Could it be something else?
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 3:02 AM
JACOBANDNICKOLAS
MECHANIC
109,700 POSTS
Did you check the wiring between the door and the door frame? It is in a rubber boot.
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 3:28 AM
CABRERA
MEMBER
4 POSTS
Yes, and there was no broken wire, I also checked the connector to the motor with the tester, and that came back negative for power
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 3:40 AM
JACOBANDNICKOLAS
MECHANIC
109,700 POSTS
The only thing you can do at this time is trace the power supply until you find where the power is lost. Not a fun job, but that is what needs done.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 3:44 AM
CABRERA
MEMBER
4 POSTS
Will do, thank you jacobandnickolas
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 3:49 AM
JACOBANDNICKOLAS
MECHANIC
109,700 POSTS
Glad to help. I just wish I had an easier answer. Let me know what you find.
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 4:09 AM
WOLFENPIXELS
MEMBER
14 POSTS
Check the feed power from the cct breaker then scout for broken wire from there
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2011 AT 11:22 PM
THIS IS MIKE
MECHANIC
686 POSTS
This was sent in by another member trying to help via email. I had the same problem as member Cabrera. My Venture Van 2002 power windows were not working. Problem is under the carpet passenger side front. The carpet gets wet. The wire connections corrode and disconnect the circuit to the window. This is more than often the problem so pull up that carpet on passenger side near to the front door sill.