want to know how to put the 3 wires back in to the plug of the knock sensor on top of the starter

2003 CHEVROLET SUBURBAN
152,553 MILES
Avatar
EFRAIN
  • MEMBER
  • 1 POST
I was replacing the starter and i pull the wires from the plug
Jan 11, 2012 at 4:41 PM
Advertisement
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
you didn't say what motor? usually wire ends are held in their plastic plugs by little tabs that stick slightly out on metal end part of wire. they get bent/smushed when ripped out. fix that and they snap back in. to know what color wire goes in which hole in plug you probably have to look at another 1 on another similar vehicle.
Jan 11, 2012 at 5:00 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.