2003 Chevrolet Monte Carlo U Install Wiper Transmission

2003 CHEVROLET MONTE CARLO
150,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
how do u install wiper transmission
Nov 2, 2012 at 1:58 AM
Advertisement
Avatar
ASEMASTER6371
  • ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
REMOVAL PROCEDURE

Remove the air inlet grille panel.
Remove the wiper motor water deflector.



Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm.



Remove the wiper motor crank arm cover.
Remove the wiper motor crank arm screw.
Remove the wiper motor crank arm from the wiper motor.

INSTALLATION PROCEDURE



Position the wiper motor crank arm onto the wiper motor.
Measure the gap between wiper motor crank arm and the bracket tab. If the gap is not 4-8 mm (0.157-0.314 in) , remove the wiper motor crank arm and repeat installation.



Install the wiper motor crank arm screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screw to 16 N.m (12 lb ft) .

Install the wiper motor crank arm cover.



Using the J 39529 , install the wiper transmission to the wiper motor crank arm.
Install the air inlet grille panel.
Install the wiper motor water deflector.
Operate the windshield wipers and inspect for proper operation.



Nov 2, 2012 at 2:00 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.