To have the diagnostic test is about 15 minutes in labor. So, if you go somewhere that charges $80/Hr, it is $20. It is an Onboard Diagnostic Tester, (OBD). Your car is the newer OBD2. They will hook up a handheld computer that plugs into the OBD port and it will give them any trouble and diagnostic codes that the cars computer senses when it is tested.
I could not find the actuator in the estimator that I use, so I had to go with my instincts and experience.
The actuator gives a Technician 5 hours to Remove and Replace. At a labor rate of $80/Hr, that is $400.0 in labor. The part is about $300 or $400, with a total of..$800.00. Now I round everything up and the repair shop you go to may only charge $40/Hr and get a used part. The PCU could be replaced under the same labor time as it is, "Overlap" because it is essentially no extra time to R&R. If you need a PCU they can run $200 or so.
I really don't think you are looking at this much, but use the labor hours so you have an idea of how long and I really just don't have a price for an actuator. The fact that I could not even find a used one on the web or a new or remanufactured is a good sign as they probably rarely fail.
Once you have the repair shop run the OBD test, your car will tell you...:) what is the most likely source is for the problem.
I hope this information gives you some well being as you take it to a repair facility to repair it. If a facility does not want to run the diagnostic while you watch, liability insurance is to blame. Ask them to test it outside as you are , "Interested to see the OBD tester." If they refuse then, you might have a suspicious repair man. Always use your first instinct when finding a repair shop. If you feel intimidated, go elsewhere. They should make you feel at ease...that is part of there job.
I hope this information helps.
Feb 22, 2011 at 4:20 PM