Advertisement

2003 Chevrolet Impala gas

98,000 MILES • 3.8L • V6 • FWD • AUTOMATIC
Avatar
MATT6
  • MEMBER
  • 1 POST
when i push my my gas petal down the car jerks like it dont want to go and the check engine light starts blinking... sometimes i push the petal all the way and itll only push 40 mph and the check engine light turns on completely? I change the fuel filter to see if I could be that but the car still acts the same.
Mar 9, 2015 at 1:29 PM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
A flashing Check Engine light indicates the most serious of conditions and means you're supposed to stop the engine right away. Too much unburned fuel is going into the exhaust system and is going to overheat and damage the catalytic converter. The place to start is by having the diagnostic fault codes read and recorded. The people at many auto parts stores will do that for you for free, but be aware those codes never say to replace parts or that they're bad. They only indicate the circuit or system that needs further diagnosis, or the unacceptable operating condition.

If the catalytic converter has already been overheated, the catalyst may have melted. That will plug the exhaust system and make acceleration nearly impossible. One clue you can look for is the exhaust will sound like a steady hiss instead of the normal "putt putt" at the tail pipe. The converter has to be replaced to fix that, but you also have to diagnose the cause of the too much fuel and fix that. Misfiring spark plugs is a common cause of misfires, especially at the mileage you listed.
Mar 9, 2015 at 2:39 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle