antifteeze leaking out of hole on side of engine block

2003 BUICK LESABRE
186,900 MILES
Avatar
LASABRE
  • MEMBER
  • 4 POSTS
Car was smoking under hood of car. When cooled, opened radiator cap, start car, then poured mix of antifreeze & water and seen it gushing out a hole on side the left side of the engine block
Sep 19, 2011 at 2:00 AM
Advertisement
Avatar
PROMECHANIC
  • ASE Certified Mechanic
  • 536 POSTS
  • ASE Certified Mechanic
I can't really tell where it is leaking from. Can you describe the area better where it is leaking?
Some of the most likely places that leaks happen on these engines are the water pump and the intake manifold gaskets.
Sep 19, 2011 at 2:38 AM
Avatar
LASABRE
  • MEMBER
  • 4 POSTS
The hole is to the right of the hole pictured and under the compartments kind of hard to get to. Like an elbow would fit both holes. Hope that helps
Sep 19, 2011 at 5:30 AM
Avatar
PROMECHANIC
  • ASE Certified Mechanic
  • 536 POSTS
  • ASE Certified Mechanic
I think it is probably an intake manifold gasket leak, but it's really hard to tell from the pic and description. Any good repair shop can do a pressure test to pinpoint the leak.
Sep 19, 2011 at 6:54 PM
Avatar
LASABRE
  • MEMBER
  • 4 POSTS
Thanks for your help. I got repaired today, they replaced the elbow tube- thermostat by-pass pipe. You're awesome
Sep 20, 2011 at 3:00 AM
Avatar
PROMECHANIC
  • ASE Certified Mechanic
  • 536 POSTS
  • ASE Certified Mechanic
Glad to see that you got it fixed.
Sep 20, 2011 at 3:14 AM
Avatar
DERRICKHAWKINS
  • MEMBER
  • 1 POST
i happen to have that same leak...how much does it run 2get fixed
Oct 1, 2012 at 7:49 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.