repaired and replaced head car just click dont want to start

2002 RENAULT MEGANE
19,000 MILES
Avatar
ARNOLDUS
  • MEMBER
  • 5 POSTS
had was redone at engineers scemed and all valves replaced
May 10, 2012 at 11:08 AM
Advertisement
Avatar
MHPAUTOS
  • ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Valve timing correct and will the engine turn over by hand? pull the plugs and it should turn easly by hand.
May 10, 2012 at 11:10 AM
Avatar
ARNOLDUS
  • MEMBER
  • 5 POSTS
I did turn it by hand but don't know if it is because head was schemed must the plugs be out when I try turning the engine by hand
May 10, 2012 at 11:37 AM
Avatar
MHPAUTOS
  • ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
no, but it will be easier to check that it turns as you are not fighting against compression, if you have good access to front crank shaft bolt, leave the plugs in if you wish.
May 10, 2012 at 11:41 AM
Avatar
ARNOLDUS
  • MEMBER
  • 5 POSTS
Just going to check tbt is in and try again thanks
May 10, 2012 at 11:50 AM
Avatar
MHPAUTOS
  • ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
ok will be on line for about another 1/2 hr or so if you need more assistance tonight as i am in Aust and its nearly 10 PM here.
May 10, 2012 at 11:53 AM
Avatar
ARNOLDUS
  • MEMBER
  • 5 POSTS

Thanks speak to u tomorow I'm a south african
May 10, 2012 at 12:12 PM
Avatar
ARNOLDUS
  • MEMBER
  • 5 POSTS
Good day I just wanted to know if there is a toolkit available for the renault and what the price is I am still busy withe the car have not worked on it since we last spke.
Thanks Arnold
May 14, 2012 at 6:45 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.