location of the wiper pulse module. Sometimes the wipers run without activating them.
Nov 25, 2012 at 1:08 AM
2002 OLDSMOBILE INTRIGUE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
WIPER DRIVE SYSTEM MODULE REPLACEMENT
TOOLS REQUIRED
J 39232 Wiper Transmission Separator
J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
Remove the air inlet grille panel.
Remove the wiper motor water deflector.
Using the J 39232, disconnect wiper transmission from the wiper motor crank arm to aid in the removal of the wiper drive system module.
Remove the wiper drive system module screws.
Disconnect the wiper motor electrical connector.
Remove the wiper drive system module from the vehicle.
INSTALLATION PROCEDURE
Position the wiper drive system module to the vehicle.
Connect the wiper motor electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
Install the wiper drive system screws.
Tighten
Tighten the screws to 10 N.m (89 lb in ).
Using the J 39520 Install the wiper transmission to the wiper motor crank arm.
Install the wiper motor water deflector.
Install the air inlet grille panel.
Inspect the wipers for proper operation.
TOOLS REQUIRED
J 39232 Wiper Transmission Separator
J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
Remove the air inlet grille panel.
Remove the wiper motor water deflector.
Using the J 39232, disconnect wiper transmission from the wiper motor crank arm to aid in the removal of the wiper drive system module.
Remove the wiper drive system module screws.
Disconnect the wiper motor electrical connector.
Remove the wiper drive system module from the vehicle.
INSTALLATION PROCEDURE
Position the wiper drive system module to the vehicle.
Connect the wiper motor electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
Install the wiper drive system screws.
Tighten
Tighten the screws to 10 N.m (89 lb in ).
Using the J 39520 Install the wiper transmission to the wiper motor crank arm.
Install the wiper motor water deflector.
Install the air inlet grille panel.
Inspect the wipers for proper operation.
Nov 25, 2012 at 1:30 AM
Advertisement