rebuild

2002 NISSAN SENTRA
100,600 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
ZELLDOG93
  • MEMBER
  • 111 POSTS
if i were to rebuild my engine due to water damage in the cylinders what parts would i need if i had to replace the piston rings
Jul 25, 2011 at 1:40 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 31,937 POSTS
Engine gasket set, ring set, i would do the bearings as well, check condition of all hoses thermostat fit new plugs and all filters coolant and oil.
Jul 27, 2011 at 12:57 PM
Advertisement
Avatar
ZELLDOG93
  • MEMBER
  • 111 POSTS
do you know a web site where i can order the parts from other then summit racing and jegs? and also what is the possibility that i would need to bore out the cylinders?
Jul 27, 2011 at 2:36 PM
Avatar
MHPAUTOS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 31,937 POSTS
Try parts train, you will have to measure the bore to see if it requires boring.
Jul 27, 2011 at 10:33 PM
Avatar
ZELLDOG93
  • MEMBER
  • 111 POSTS
ok thanks i will try that but i think i looked at parts train but i dont remember if they had the right parts for the right prices and i have a place to get my engine bored out that costs like $20 a hole
Jul 27, 2011 at 11:13 PM