rear coil springs

Avatar
ANTONIO 212
  • MEMBER
  • 1 POST
show me how to change springs
Feb 19, 2011 at 6:46 AM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
REAR COIL SPRING
Removal & Installation
1. Raise and support vehicle. Remove wheel. Set jack under rear lower link.

2. Loosen fixing bolt and nut between rear lower link and suspension member, and then remove fixing bolt and nut between rear axle and rear lower link.

3. Slowly lower jack, then remove upper seat, coil spring and rubber seat from rear lower link.

4. To install, reverse removal procedure.

5. heck that the projecting part inside the upper seat and the flange part of bracket are attached as shown in Fig. 2 . Check that the projection part outside the upper seat directs to vehicle front. Position the hollow of the rubber seat with the groove part of rear lower link to install. See Fig. 2 . Install coil spring with the side of two paint markers directing to lower side.
Fig. 2: Installing Coil Spring


© 2008 Mitchell Repair Information Co., LLC.
Feb 19, 2011 at 7:30 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle