SPONSORED LINKS

Maf sensor

Tiny
EEPEEZY
  • MEMBER
  • 2002 NISSAN ALTIMA
  • 6 CYL
  • FWD
  • AUTOMATIC
I installed a new maf sensor and the engine does not accelerate at all
Thursday, February 10th, 2011 AT 3:39 AM

2 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Are you sure it's not a transmission problem-if not

Could be caused by one of the following below

Oxygen sensor.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Crankshaft position sensor
Knock sensor
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.

Note:If it doesn't apply disregard it and keep testing.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, February 10th, 2011 AT 10:29 PM
Tiny
EEPEEZY
  • MEMBER
  • 9 POSTS
Well it messed up during a snow storm and the engine light came on, then it had no power but rpms only went up to 2500. I put a computer deal to get the codes and it showed p0102. Mass air flow circuit low input. Does the same without the maf plugged. Bought a new one, installed it. When plugged, it idles even with the pedal to the floor. Idk
Was this
answer
helpful?
Yes
No
Friday, February 25th, 2011 AT 3:28 AM

Please login or register to post a reply.

Related Mass Air Flow Sensor Replace/Remove Content

Mass Air Flow Sensor Replacement
GUIDE
Mass Air Flow Sensor Replacement
After starting the engine post sensor replacement, the sensor instantly calibrates itself so there is no learn time required. This sensor is subject to debris and ...
VIEW MORE

Sponsored links