Montero engine swap 3.0 to 3.5

Tiny
SPECIALIST
  • MEMBER
  • 2002 MITSUBISHI MONTERO
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 89,000 MILES
2002 Mitsubishi Montero 3.0 with 89,000 miles
6 cyl 3.0L Automatic 4 Wheel Drive
2002 Mitsubishi Montero engine swap

hi dear sirs,
I am about to buy an engine for my mit montero 2000. My engine is a 6G72 3.0L and I can get a 3.5 6G75. My question is, would this engine fit in my 3.0. Do I have to change wire harness or support brackets. What is all I have to look for to swap this engine in my montero.
thanks
Friday, August 5th, 2011 AT 1:21 AM

7 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
It should be 6G74 that you are refering to. The two engine uses different system, single cam and twin cam engines and the wireharness etc are all different.

Unless you are able to get a complete set of wireharness with the PCM, engine and transmission, the single engine transplant is not possible.
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 11:42 AM
Tiny
SPECIALIST
  • MEMBER
  • 6 POSTS
Hi, you are right it is a 6G74 3.5 L pull out a mit mon sport. Sorry about the misspell.I read here in a message about swapping this engine, but it was not clear for me what were all the mods he had done.
Thanks
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 11:53 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
If you are able to get a half cut, the job would be easier. You can just transfer the complete lot over with some minor rewiring to get it done.
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 12:18 PM
Tiny
SPECIALIST
  • MEMBER
  • 6 POSTS
Hi, do I need the tranny or will the 3.5 match the 3.0 tranny.I cannot get a half cut.I can get engine wiring, mounts, ecm etc but not the half cut.
Thanks
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 12:33 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
The transmission is definitely not going to fit.

I guess you would have to forget the idea. I just reconfirmed with a friend and he has some additional information indicating the job requires welding work on the cross members and engine mount brackets.
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 12:51 PM
Tiny
SPECIALIST
  • MEMBER
  • 6 POSTS
Ok, thanks will follow your advice.
Was this
answer
helpful?
Yes
No
Friday, August 5th, 2011 AT 2:50 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Need to close question with this reply.
Was this
answer
helpful?
Yes
No
+1
Sunday, October 21st, 2012 AT 5:11 AM

Please login or register to post a reply.

Sponsored links