2002 Mazda Millenia Replaced Timing Belt Accesories Done Tried Start Car Will

2002 MAZDA MILLENIA
165,000 MILES
Avatar
ZACHG1
  • MEMBER
  • 1 POST
Replaced timing belt and accesories. When I was done and tried to start car it will crank beauitfuly but wont start. Tested and it is not getting any spark at the plugs. Suspect I damaged the Crank position sensor. When I test resistance I get between 499 and 500. What should I be reading? I searched internet and found one site that said between 520-580 and another that said between 950 and 1250. Please help! If not CPS then what else could it be?

Thank you!
Feb 5, 2013 at 12:00 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
did you re check all your work?? did it run before the repair???

the crank sensor needs to be scoped to determine whether it is working or not.

Roy
Feb 5, 2013 at 1:33 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.