2002 Mazda Millenia Car jerks when accelrating

2002 MAZDA MILLENIA
190,000 MILES • AUTOMATIC
Avatar
JAMESJONE98
  • MEMBER
  • 3 POSTS
My 2002 Millenia jerks a bit when it's accelerating. Whenever I try to accelerate, it jerks for a few seconds and then it starts to accelerate. It starts fine, it just takes time to accelerate because of the jerking.

Also, it has been smelling like burnt rubber after I've been driving and turn the car off.
Jan 9, 2014 at 6:16 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Has the check engine light come on? When was the last tune up?
Jan 9, 2014 at 6:25 PM
Avatar
JAMESJONE98
  • MEMBER
  • 3 POSTS
No, the check engine light has not been on. I just bought the car Wednesday from a used car lot. Should i set up an appointment to get it looked at tomorrow?
Jan 9, 2014 at 6:50 PM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Because you mentioned that you smell something burning, I think it would be a good idea. Also, is there a warranty on the vehicle since you just got it?
Jan 9, 2014 at 6:57 PM
Avatar
JAMESJONE98
  • MEMBER
  • 3 POSTS
Yes. I purchased a warranty when I got the car. I'll setup an appointment to get the car looked at. do most warrantys cover tune ups? or is that usually an out of pocket thing?
Jan 9, 2014 at 7:14 PM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
A tune up is considered general maintenance. Therefore, it isn't covered by a warranty.
Jan 10, 2014 at 5:38 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.