Lexus GS300 Transmission Solenoid C

Tiny
PROTON
  • MEMBER
  • 2002 LEXUS GS 300
  • V8
  • 2WD
  • AUTOMATIC
  • 101,500 MILES
My OBD II scanner shows codes P0763 and P0715 for my 2002 Lexus GS 300. How do I replace the transmission Solenoid C assembly?
Saturday, August 13th, 2011 AT 6:43 PM

7 Replies

Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Need to drop pan are on valve body. But O/D speed sensor better place to start.
Was this
answer
helpful?
Yes
No
+3
Saturday, August 13th, 2011 AT 7:18 PM
Tiny
TOYINFOLARIN1
  • MEMBER
  • 5 POSTS
Pls can you give a bit more detail? Thank you
Was this
answer
helpful?
Yes
No
+3
Saturday, November 26th, 2016 AT 5:34 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Hi Toy
Do you have the same vehicle? And are the codes the same?
Was this
answer
helpful?
Yes
No
+3
Sunday, November 27th, 2016 AT 11:17 AM
Tiny
TOYINFOLARIN1
  • MEMBER
  • 5 POSTS
Not really sir. I drive a 2006 lexus GS300. It doesn't shift past gear 3. D scan result gives d error code p0761 - shifting solenoid 'c' or stuck off. My tranny mech replaced d transmission fluid and d cleaned out d gear filter of all debris. We tested d solenoid and it gave a click sound, which verifies it's ok. Drove it again after these efforts and it still didnt shift past third gear. I observed The transmission fluid was very very dirty. Guess it had never been changed b4 I purchased d car at about 150 miles. Pls what do I do next. I really need help.
Was this
answer
helpful?
Yes
No
+10
Sunday, November 27th, 2016 AT 2:30 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Let me do some research and will let youknow what to do next
Was this
answer
helpful?
Yes
No
Sunday, November 27th, 2016 AT 2:48 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Ohm Check Shift Solenoid valveS3 should be 11-15 ohms. Loacated on side of trans a row of four S3 is second from right. If this checks good most likely cause is worn clutch material in valve body a rebuild will need to be done
Was this
answer
helpful?
Yes
No
+1
Sunday, November 27th, 2016 AT 3:01 PM

Please login or register to post a reply.

Sponsored links